Go Back   Jeep Cherokee Forum > Garage

CherokeeTalk.com is the premier Jeep Cherokee Forum on the internet. Registered Users do not see the above ads.

Projekt 318
CT99XJ's Avatar
CT99XJ CT99XJ is offline
That Guy
 
Join Date: Jul 2009
Posts: 5,971
Garage
Vehicle Name Projekt 318
Year 1996
Make Jeep
Model Grand Cherokee
Color Tan
Packages Limited
1996 Jeep Grand Cherokee
History This is my third ZJ of this color, but my first V-8 and first Limited. The roof needed some paint, there were some electrical issues, the exhaust sucked, it had a 249 (yuck) and the motor/tranny had some serious leaks. But for $950, it was a perfect candidate for the unibody swap I was aiming to do. Plus it's a burnout machine.
Exterior
*CB Antenna
*LED pods in factory fog location
*Hella 500's on bumper w/Silverstar H3's
*Lund visor and window deflectors
Gold trim swapped to silver (mostly, not done yet)
*TJ gas bezel

Interior
*5.9 Limited door cards
*Stereo + speakers w/XM and iPod hookups
*New spare tire J-hook to work with 33" spare
*Hella fuel pump cutoff switch in center console

Under the Hood
*Magnum 5.2
*Ford Racing 24lb injectors
*Accel ignition coil
*Accel plug wires
*Champion plugs
*MSD cap and rotor
*K&N air hat from Dodge 3.9 Dakota
*K&N drop-in filter
*Modified Holley throttle body (deflectors milled off, stock bore)
*Manually adjustable MAP sensor voltage regulator
*160amp alternator
*TorqFlo fan clutch
*FlowKooler water pump, factory thermostat
*Factory aux. trans cooler removed, replaced with 10,000 GVW cooler
*Factory 4.7 Durango power steering cooler
*WJ PS pump
*Magnaflow 2.5" shorty cat w/Spintech Pro Street muffler, 3" dumped before rear axle
*Torque converter lockout switch
*Hood vents
*WORKING A/C
*NP249-NP242 case swap

Suspension
*LP30 front, factory LSD, 3.73's, HD LCA mounts, U-joint shaft swap, Alloy USA axle tube seals
*D44a rear, factory LSD, 3.73's, D60 yoke (1330 u-joint)
*
*6.5" Clayton XJ front coils, net 5.5"
*4" TJ front coils in rear, net 5.5-5.75"
*Clayton crossmember
*Clayton long arms
*Clayton HD front track bar w/bracket
*One-ton steering conversion with Chevy K-10 tie rod ends, 1.5" x.25" DOM rods
*JKS disconnects
*Addco front sway bar
*12.5" travel Bilstein 5100's front
*13.5" travel Bilstein 5125's rear
*Crown braided SS brake lines
*DPG rear bumps

Wheel and Tire
*Factory TJ Ravines, 15x8, 5.5" backspacing
*1.25" Spidertrax spacers
*33x12.50 BFG KM2's
*Net backspacing: 4.25"
Views: 662

All times are GMT -6. The time now is 10:48 PM.



Copyright ©2000 - 2017, Jelsoft Enterprises Ltd
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
 

Garage Plus vBulletin Plugins by Drive Thru Online, Inc.

Content Relevant URLs by vBSEO 3.6.0