[KrakenHockey]

I have a 2011 Grand Cherokee that the wiring between the drivers door and the body has started to fail (broken wires) and I was wondering if there was a wiring harness I can buy to replace it. My soldering is not the strongest and don't was a lot of splices in the wires. Any ideas, Thanks

 

[Gluckmysock]

u can replace the harness. it has a connector inside the door frame, the wire goes through a rubber boot and connects up at the door window switch. I don't know off hand, where you can buy a new harness. you may have to hit the junk yard. I did find this on ebay. but it seems kinda pricey. Jeep WK wiring harness - ebay

 

[pavlov]

Hey Gluckmysock .... I have had an occasional broken wire in my driver's door harness too ( the one that turns off the alarm when you use the key in the lock seems to be the usual culprit).... Just wondering ( because I have not really looked into it)..... does the harness on the OTHER side.....the side that goes into the body..... have a plug connector? Or do the wires just go all over the place?

 

[Gluckmysock]

follow the harness through the rubber boot. some times the connector is in the rubber. or just behind then the kick panel on the left side of the foot well.

 

[pavlov]

Will do! (one of these daze) Thnx! ... jc