Joined
·
1,850 Posts
You're gonna have to pull it to get the part number off of it. It is located behind the driver's side knee/kick panel. It is facing the firewall and fastened to the backside of the metal support frame for the dash.Hi, first post so i hope i am in the right place. I am looking to replace the BCM on my 98 zj. I have no low beam lights, no high wipers, and my dash lights flicker on and off fairly often. From what ive read this seems the be the cause of my issues. My question is can i use the BCM and ECM from a 1995 ZJ on a '98? I'd rather not have to have a replacment programmed since i don't know how to go about it. I believe i have security since the fob has an alarm function but i could be mistaken, i think the '95 was the same. Any help is appreciated
I have about five or six spares. I believe one or two of them are out of a 96/97(diff. part numbers). If you get it pulled I can sell you one at a reasonable price, but buyer beware. I have not tested them. They came straight out of the junk yard and into a spare parts bin. You might find them on ebay, but be very sure they're what you need; most people won't give any sort of returns. I've tried before myself.
Be sure it is the body control module. It could be a bad grounding location. Most of those described circuits terminate at the passenger side fender under the hood. Clean up the grounding location on the passenger side fender walll, just behind the battery and in front of the relay control / power distribution center. Unbolt them from the fender wall and make sure the metal is shiny and grey/metal colored. Then reattach. Try out the circuits...
Good luck!