Jeep Cherokee Talk banner

1 - 20 of 21 Posts

·
Registered
Joined
·
330 Posts
Discussion Starter #1
I want this stuff gone. I know a few who live "somewhat" close.

These are all stock parts off my 2000 4.0L/AW4/242 TC

1- rear drive shaft good shape, good u-joints
1- tierod with almost new TRE's
1- trackbar
1- trackbar frame mount
1- "trimmed" front bumper
2- rear leafsprings NO sag that I could tell

Might be some other misc. stuff, I'll list it if I find any.
 

·
Registered
Joined
·
330 Posts
Discussion Starter #3
You selling this stuff or is it "take it or I'm scrapping it"???
I'm hoping someone that can use it will come and get it. I guess I'm in a giving mood.:cheers: If someone dosen't come and take them, yes I will be scrapping the stuff. I need room in the garage.:thumbsup:
 

·
Registered
Joined
·
330 Posts
Discussion Starter #5
ill take the rear leafs since mine are sagin a little
i dont know when i could get down there though
I grew up in Crawfordsville, and I am up there often. It is about 20 miles south of Lafayette. I know it would still be a drive but I could meet you there. A little closer that coming clear down to Indy.
 

·
Budget Master
Joined
·
1,145 Posts
can you take a pic of the trimmed front bumper.
 

·
Registered
Joined
·
330 Posts
Discussion Starter #8
Here is a picture of it when it was on my Jeep.


There is also a mounting bracket on the right side of the bumper for a flag if one is needed. The bumper has been in the garage since I replaced it.
 

·
Budget Master
Joined
·
1,145 Posts
o looks nice but i dont realy need it...
 

·
Registered
Joined
·
330 Posts
Discussion Starter #11
If you still have the trak bar frame mount I would pay shipping to 25414.
Yep, still got it. I'll try to find a box and get a shipping price out to you tomorrow. Just a reminder, it is the STOCK trackbar frame mounting bracket.
 

·
Registered
Joined
·
330 Posts
Discussion Starter #13
Long shot, but your not getting rid of your front driveshaft are ya?

I'd pay for it and pay for shipping as well.
Most likely not. I'm getting ready to install a HP D30 and will probably be using the stock front DS again.

If I do end up using the stock shaft, I will have a Tom Woods custom front DS for sale though. It is his multiple double cardan joint shaft, it has a cardan joint on each end. Only reason I have it is because I have a LP axle now, and had vibration problems after I FINALLY got the caster angle right.
 

·
Registered
Joined
·
345 Posts
do you still have those rear leaf springs and the track bar? I would gladly make the trip to pick them up. I live in Valparaiso.:bow:
 

·
Administrator
Joined
·
6,426 Posts
hmm. is the track bar the stock one too?
 
1 - 20 of 21 Posts
Top