Jeep Cherokee Talk banner
1 - 1 of 1 Posts

·
Registered
Joined
·
53 Posts
Discussion Starter · #1 ·
96 XJ here and I'm rebuilding what was once a huge hole in one of my rocker panels. I've riveted in 1/8" diamond plate aluminum for the backer support and now I've got 2 good coats of bondo on there. I'll end up going over the 1/4" thickness limit for bondo, oh well.

So my question is...how do I go from where I am now on the left side of the pic to building and smoothing this out so that it's paint ready and in the shape of the rocker panel on the left.

I've got a can of color matched red and high build primer on the way.

Automotive lighting Automotive tire Water Road surface Asphalt


Automotive tire Rectangle Wood Grey Wall
 
1 - 1 of 1 Posts
Top