Jeep Cherokee Talk banner
1 - 13 of 13 Posts

· Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
Okay guys so I just bought a 1988 Cherokee. Who ever had it before me did a lot of modifications to it and I cannot figure out for the life of me why I have no signals or hazards. I don’t get anything from the arrows on the dash either can anyone help me with this. Would be much appreciated.
 

· Super Moderator
Joined
·
13,576 Posts
The first thing to do is check your fuses, Then make sure you have a hazard flasher and turn signal flasher installed.
 

· Super Moderator
Joined
·
13,576 Posts
it could be the switch on column. Hear is the turn signal wiring It's for an 89 but should be the same.

Rectangle Slope Font Parallel Diagram

Schematic Font Parallel Rectangle Technical drawing
 

· Registered
Joined
·
7 Posts
Discussion Starter · #11 ·
And I just got these for 88. View attachment 230160
Awesome thank you. This is making me want to rip my hair out. I’m leaning towards the switch in the column it’s really hard to actually use the switch like you almost have to jam it on. So I think I’m going to replace that next and see if it is the problem. Next question lol. What’s the word on the Quadratec nitro 8.0 shocks? I can’t find much about them online just looking for some feedback on the if anyone knows anything it would be appreciated
 

· Super Moderator
Joined
·
13,576 Posts
why the nitro's? I just installed Rubicon Express shocks and they are basically Bilsteins, cause thats who makes them.
 
1 - 13 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top